Cadoro Plasters
Microestil Plus Base Microcement
Art: MIC-PLUS-BASE-20KG
Description
s
Microestil®PLUS BASE
PRODUCT INFORMATION
Decorative mortar for the design of continuous surfaces on pavements and coatings.
TECHNICAL DATA OF
APPLICATION
Application area On floors and walls both inside and outside, for creating decorative continuous
surfaces in houses, shops, restaurants, hotels, exhibitions, etc
Product description
Mortar based on calcium cements and aggregates selected powdered additives
that give excellent properties. Excellent adhesion on any stable support, high hardness and flexibility. Suitable for the application of the smoothing coats in the
Microestil® Decor system or mass dyed for Microestil Rustic system.
Surface preparation
The surface must have a minimum strength of 1.5 N / mm², must be clean, free of cracks, oil remains, fats and paint and any contaminants that will inhibit adhesion to the support.
If in doubt, carry out tests. Support must be prepared by mechanical means such as diamond or milling and subsequent sucked the surface.
Due to the low thickness of the coating (2-3mm), leveling levels of support higher are required.
Cementitious surfaces and supports different absorption will be print with or PRIMER P541 or ESTILPOX P100 sprinkling quartz aggregate to saturation on fresh coat; excess aggregate will be remove the next day.
If the support has moisture due to groundwater or a capillary, we advise not use our system because the moisture would cause destruction.
Colour White.
Conservation Approx. 12 months in dry places into their original package.
Base Water
Mixing ratio with water
Package
20 kg 5280grams water
10 kg 2.5-2.75 lts
Consumption 0,8-1,2Kg / m² per coat.
Use
Mix Microestil® PLUS BASE with clean water or pigmented with Microestil® COLOR TONER, by low speed mixer until to get a homogeneous and smooth mass mix for 3 min, let rest 10 minutes and then remix again for 30 seconds low speed. The mixture can be used for 1 hour, after that time the remaining mixture is discarded. The ambient temperature should be between 10ºC and 30ºC.
Pour the mortar in small amounts and then apply thin coat with a smooth trowel. Theinterval between coats must be at least 2 hours. Maximum coat thickness 3mm.
We advise to seal coatings with system products.
Workability 20ºC: 1 hour.
Microestil®PLUS BASE
Technical
datasheet
Hydraulic micromortar.
Solid content: 100 %
Extension: 10-20% for 1-3mm.
Mixture density: 1.80 g / cm³.
VOC 'S: 0 %
Character: nonionic.
Dry
Total harden: 28 days.
Traffic: 24 hours.
Interval between coats: 2 hours.
Cleaning After using the tools should be cleaned immediately with water
Cautions
It contains cement that it reacts alkali. Protect skin and eyes. In case of contact,
rinse with water. In case of eye contact also visit a doctor.
Once hardened is harmless.
Updated coverage reference: Use the estimates in this section in place of earlier coverage figures elsewhere in this description.
Estimated coverage by container
| Container | One coat | Two coats |
|---|---|---|
| 5 kg | 47 sq ft | 23 sq ft |
| 20 kg | 187 sq ft | 94 sq ft |
Manufacturer consumption: approximately 2.3 kg/m² for two coats combined, based on the supplied July 2025 technical sheet. One-coat estimates assume half that consumption; actual coat thickness may differ.
Two-coat figures cover the same area twice. Estimates are before waste. Actual coverage varies with surface texture, preparation and application thickness. These figures describe this product only; primers, base coats and protective finishes may be required separately.