Cadoro Plasters
Microestil PoolCem F6 Microcement
Art: 00030
Description
We sell and stock PoolCem micro-cement from Spain. Available in eggshell white and various other colors. Suitable for pools, fountains, showers and wet rooms and flooring installs. F6 is required as the base coat for showers and floors. If only doing walls and non wet areas F2 is only needed.
See the estimated consumption and coverage table below.
Unlike “normal” microcements, PoolCem micro-mortars have been developed to create coatings resistant to constant immersion, being waterproof on the positive side but breathable on the negative side. These properties are typical of the micro-mortar, they do not depend on any primer or final varnish.
In constant immersion, PoolCem coatings, being natural, unlike synthetic coatings, can be affected by hyper-chlorinated water and/or too high or low pH (acidic water).
The composition, among other components, incorporates permanent water repellents, hydroxides, resins and specific additives, which once the micro-mortar has completely set, a very compact coating is obtained in its structure, avoiding possible blistering due to osmotic action. In this way the coating remains unchanged in humid environments.
In constant immersion it is not recommended to varnish the coating since the same water protects it from most possible organic stains, a varnish would nullify part of the properties of the micro-mortar in immersion.
On terraces and outdoors it behaves exactly the same, bearing in mind that it will not be subjected to the same pressures as it is in immersion, we recommend varnishing the coating with a one-component water-based varnish (ESTILPUR 1C), this allows the coating to breathe and offers you some protection. Said varnish must be renewed every 3 or 5 years to avoid premature erosion of the coating.
Indoors, it can be protected with the ESTIPUR 1C varnish or with the two-component varnishes ESTIPUR PU20 or ESTILPUR DV, but with the two-component varnishes the waterproofing properties of the micro-mortar will be cancelled, and its application indoors is merely due to the hardness and aesthetics of the coating.
Estimated coverage by container
| Container | One coat | Two coats |
|---|---|---|
| 20 kg | 130–144 sq ft | 65–72 sq ft |
Manufacturer consumption: approximately 3–3.3 kg/m² for two coats combined, based on the supplied July 2025 technical sheet. One-coat estimates assume half that consumption; actual coat thickness may differ.
Two-coat figures cover the same area twice. Estimates are before waste. Actual coverage varies with surface texture, preparation and application thickness. These figures describe this product only; primers, base coats and protective finishes may be required separately.